Ep. 9 1969 FORD TORINO STATION WAGON PARTS CAR “Project Redneck” Crown Vic Frame Swap / Install
In this video I was showing the 1969 Ford Torino station wagon I got for the crown vic frame swap of the 1968 Mercury Montego station wagon. I really needed the wagon as I needed […]
4 door to 2 door conversion measurements for 68 Ford Torino
I was asked to help with some measurements of the 1968 2 door Ford Torino. The measurements should help with the 4 door to 2 door conversions. I made the picture below with all the […]
Ep. 8 CUTTING FLOORBOARD FOR FRAME INSTALL “Project Redneck” Crown Vic Frame Swap / Install
In this video I cut out all the parts of the unibody Mercury Montego wagon floorboard to get the crown vic frame swap to fit / tuck all the way in. I had to cut […]
Ford 8in / 9in Ring and Pinion Gears Install. With Pinion Preload, Gear BackLash, Pinion Depth Tool
I was installing new ring and pinion gears into an 8in rearend, for a 1968 Ford Torino GT, and decided to film the 3.80 gear swap process. Its basically the same procedure for a 9 […]
Ep. 7 Car Mockup … Digital Stance “Project Redneck” Crown Vic Frame Swap / Install
Just wanted to do a quick video of the car mockup I did to test different stances for the car. I think this helped a lot, because doing this has possibly changed my mine on […]
Ep. 6 Planning 5.4 DOHC 32v Engine? “Project Redneck” Crown Vic Frame Swap / Install
I was going to keep the 4.6 2v engine, and decided to get a F-150 truck intake manifold for the PI engine to help drive torque better. It would also have a forward facing […]
Subscribe to my YouTube channel
